Lifebreath CAF-02-MB Uživatelský manuál stáhnout pdf (Strana 27)

Drain Line

The ventilation portion of the Clean Air Furnace

has two drain pans for removing condensation,

which may occur on the heat recovery core

during cold weather.

Piping

The hot water piping between the hot water tank

and the Clean Air Furnace should be new

copper type, and should not be treated with

chemicals, sealant or anything else, that will

interfere with the purity of the potable water. Only

non-lead, low temperature solder is

permitted for sealing copper joints.

Where possible the length of pipe should not

exceed 200' total equivalent length. Any piping

running through unconditioned space must be

insulated to prevent heat loss, and possible

freezing of the line.

Stickers indicating direction of flow, (Supply to

furnace, and Return to water heater) are

labeled on the outside of the cabinet. Do not

reverse these lines, as this will cause the unit to

malfunction.

For piping conventional water heaters,

connections to and from the Clean Air Furnace

to the water tank should be made at the point

where the pipes leave the tank vertically. A "T"

fitting used in each vertical line, with the Clean

Air Furnace piping connected to the horizontal

side of this fitting, will work best in avoiding air

locks in the circulation pump of the furnace.

*Note: Remove shipping block from underneath

pump and discard.

DRAIN

SPOUT

TAPE

THROUGH KNOCKOUT

TO DRAIN

TEE

CONNECTOR

DRAIN

SPOUT

KNOCKOUT

HRV Drain Line Diagram

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Komentáře k této Příručce

Žádné komentáře

Lifebreath CAF-02-MB Uživatelský manuál Strana 27

Komentáře k této Příručce